HID DTC400E/C30E/M30E User Guide - Manual (Page 234)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 6-110
Using the Resin Heat (K) Adjustment (Settings)
Printer uses when printing with the resin black panel(s) of a full-color Ribbon or when printing
with a resin-only Ribbon by adjusting the Resin Heat slide.
Step Procedure
1 Adjust the Resin Heat, Front (K) or the Resin Head, Back (K) as needed.
• Move the slider to the left to cause less heat to be used in the printing
process, causing resin images to be lighter or less saturated.
OR
• Move the slider to the right to (a) cause more heat to be used or (b)
cause the resin image to be darker or more saturated.
(Note: This control can be helpful for fine-tuning the transfer of resin text
and bar codes.)