HID DTC400E/C30E/M30E User Guide - Manual (Page 233)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 6-109
Using the Flipper Smart Angle Offset Option
Use this option to change the Flipper angle relative to the default smart card loading position.
This is done in order to adjust travel to and from the Flipper and the Smart Card Docking
Module.
Step Procedure
1 Enter a negative value to decrease the amount of Flipper angular movement
from the home position to the smart card loading position.
Or
Enter a positive value to increase the amount of Flipper angular movement
from the home position to the smart card loading position.
(Maximum Adjustment Range: The maximum adjustment range is
± 5. 1 is
approximately 1 degree.)