HID DTC400E/C30E/M30E User Guide - Manual (Page 120)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 5-14
Question Answer
Can I print from my PC to
an Ethernet Printer on a
different network segment? Yes. If you know the IP address of the Printer on any
segment of your network, you will be able to print to it.
Can I use IP Tracer to
locate Printers on a
different network segment? No. The IP Tracer can only locate Printers located in the
same network segment (as the PC running IP Tracer).
How do I upgrade the
Printer Firmware in my
Ethernet-enabled Printer? This is done in the same manner as a USB connected
Printer. The PC doing the upgrade must have a Driver
installed for the Fargo Printer to be upgraded.
Follow this procedure.
1. Run the Fargo Workbench Printer Utility from the start
menu: Go to the Start -> Programs -> Fargo -> Fargo
Workbench Printer Utility -> Fargo Workbench.
2. Select the Fargo Printer to upgrade from the drop-
down box.
3. Go to the Firmware Updates tab.
4. If you need to download the update file from the
Internet, select the Download Firmware button.
5. Choose the update file with the Select Firmware
button.
6. Put your Printer into the upgrade mode. See the
instructions for your specific Fargo Printer.
7. Select the Send Firmware button.
What is the default User
name and password for
the Printer? The default passwords are blank (i.e., an empty string).
• The default Users are as follows: root as the
administrative User and guest as a non-administrative
User.
• The Printer supports four (4) Users.
What if I lose the password
for my Printer or it is not
accepted? Factory default settings will be restored to the Printer if
power is applied to the Printer with Dipswitch 1 in the ON
position and Dipswitch 2 in the OFF position.
(Note: This will reset all Print Server settings, which
includes static network settings, user configurations and
user passwords.)