Karen atkins – HID DTC400E/C30E/M30E User Guide User Manual
Page 212
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
6-88
3
Measure the total size for the area and enter those dimensions into the
dimension boxes. (Note: The minimum size an area can be is .2" x .2" /
5mm x 5mm.)
* 172355*
Karen Atkins
Access Level-2
ID# 1234478
1.2“
1.8“
4
a. Once the area is sized properly measure from the lower left corner of the
card up and over to the lower left corner for the defined area to begin.
b. Enter these values into the X and Y boxes.
(Note: The card grid lines are spaced at .2 inch / 5mm intervals.)
5
a. Print the card design and note how the image is oriented on the card as it
ejects from the Printer. (Note: The location of a defined area is based on
the card orientation as it exits the Printer.)
b. Measure the defined area location based on the printed card. (Note: If
selecting Rotate Front 180 Degrees, the image will appear upside-down
as it exits the Printer. In this case, position the defined area opposite to
the measurement from the onscreen card design, which will appear right
side up.)