Karen atkins – HID DTC400E/C30E/M30E User Guide User Manual
Page 191
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
6-67
• Determine the area of the card needed to define for a signature panel with
a different size and location than the Driver's standard Omit Signature
Area setting. (Note: This area is indicated by the dashed outline.)
• Determine the area size by actually printing a card and looking at it in the
same orientation as when it exits the Printer.
3
Measure the total size of the desired area and enter those dimensions into the
dimension boxes. (Note: The minimum size an area is .2" x .2" / 5mm x
5mm.)
.35“
1.9“
Karen Atkins
Access Level-2
ID# 1234478
4
Measure from the lower left corner of the card up and over to the lower left
corner of for the defined area to begin and enter these values into the X and Y
boxes. (Note: The card grid lines are spaced at .2 inch / 5mm intervals.)