Resolving the excessive resin printing problems – HID DTC400E/C30E/M30E User Guide User Manual
Page 96
Advertising
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
4-49
Resolving the Excessive Resin printing problems
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1
Review the following information.
• Symptom: Black resin text and barcodes appear smeared or too thick.
• Printer Error State: None
• Driver Monitor Error Display: None
2
Reduce the Resin Heat setting within the Image Color tab of the Printer Driver.
See the Using the Image Color tab (C30e/M30e).
3
Reduce the Image Darkness.
Advertising