HID DTC400E/C30E/M30E User Guide User Manual
Page 80
Advertising
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
4-33
d. To cancel the print, press the Cancel button from the Driver dialog or
Cancel the button on the Printer.
4
Test the Card Sensor.
e. Remove the rear cover.
f. Using a Digital Voltmeter, connect the negative lead to ground.
g. Connect the positive lead to Pin 10 of J4.
• If
blocked, the Sensor should read 4.9 to 5.5 VDC.
• If
unblocked, the Sensor should read 0.15 to 0.18 VDC.
h. If the voltages do not read correctly, replace the Sensor. (Note: Contact
an authorized repair center)
Advertising