HID DTC400E/C30E/M30E User Guide - Manual (Page 236)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 6-112
Using the Erase Temperature Offset
Step Procedure
1 Adjust the Erase temperature for the rewriteable cards as needed.
• Increase
the Current Setting to cause more heat to be used in the
erasing process.
OR
• Decrease
the Current Setting to cause less heat to be used in the
erasing process.
(Note: Erase Temp Offset provides user ability to control the Printhead heat
level when the Erase Operation is performed. Appropriate heat levels should
be applied for the proper erase process. This setting should be adjusted for
proper erasure)