HID DTC400E/C30E/M30E User Guide - Manual (Page 12)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 1-5
9 The Print Ribbon Sensor looks for the Yellow panel. (Note: The Print Ribbon
Encoder detects number of revolutions, required to use an entire color panel.)
(C30e & DTC 400e only)
10 The Print Stepper Motor engages.
11 The Card Feed Sensor detects trailing edge of card.
12 The Print Stepper Motor queues card to the middle of the platen Roller. All Stop.
13 The Print Headlift Motor engages.
14 The Print Headlift Sensor detects the closed state.
15 The Print Headlift Motor disengages.
16 The Print Stepper Motor engages.
17 The Print Cover Sensor checks for a closed state.
18 The Ribbon Drive Motor engages.
19 The Image data is burned by the Printhead until the image data is depleted. All
Stop.
20 The Thermistor engages the Printhead Cooling Fan to maintain proper operating
temperature.
21 The Headlift Motor engages.
22 The Print Headlift Sensor detects an open state.
23 The Print Headlift Motor disengages.
24 The Print Stepper Motor engages.
25 The Print Ribbon Drive engages.
26 After Ribbon advances a few encoder clicks, assume Ribbon free of card. All Stop.
27 Repeat steps 9 through 22 for the appropriate number of color/overlay panels.
28 The Card is ejected from the singled-sided Printer.
OR
The Card Feed Stepper engages to queue the card for the Flipper Table for the
dual-sided Printer.
29 All Stop.