HID DTC400E/C30E/M30E User Guide - Manual (Page 153)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 6-29
Using the Resin Heat (K) option (Front and Back)
Use this option to control the amount of heat the Printer uses when printing with the resin
black panel(s) of a full-color Ribbon or when printing with a resin-only Ribbon by adjusting
the Resin Heat slide.
Step Procedure
1 Adjust the Resin Heat, Front (K) or the Resin Head, Back (K) as needed.
• Move the slide to the left to cause less heat to be used in the printing
process, causing resin images to be lighter or less saturated.
OR
• Move the slide to the right to (a) cause more heat to be used or (b) cause
the resin image to be darker or more saturated.
(Note: This control can be helpful for fine-tuning the transfer of resin text
and bar codes.)