Using the overlay / print area, Using the overlay / print area -64 – HID DTC400E/C30E/M30E User Guide User Manual
Page 188
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
6-64
Using the Overlay / Print Area
Use these Overlay / Print Area options to control both the print and overlay together or
control each individually. (Note: Determine whether to use the Frontside option (via the
Front radio button) or the Backside option (via the Back radio button).)
Step Procedure
1 Select
For Print and Overlay for the defined area to apply to both the printing
and overlay process.
OR
Select For Overlay Only for the defined area to apply only to the overlay
process. (Note: In this mode, printing will still be allowed over the entire card
and only the overlay will be affected.)
OR
Select For Print Only (No Overlay) for the defined area to apply only to the
print process. (Important: In this mode, the overlay is completely disabled so
it will not be applied.)
Caution: An overlay or an overlaminate must protect dye-
sublimation printing or it will quickly begin to wear or fade.