EXFO FTB-800 Series for FTB-1 - Manual (Page 149)

Test Setup - Test Configurator, Timer, and System
NetBlazer 139
Interface - Port (Fibre Channel)
Interface - Port (Fibre Channel)
From the Test menu, tap Setup, and the Interface tab.
Physical Interface

Port allows the selection of either Port 1 or Port 2.

Speed allows the selection of the fibre channel speed: 1X, 2X, 4X, 8X,
or 10X for Port 1; 1X, 2X, or 4X for Port 2.

PSP (Link Protocol) (Primitive Sequence Protocol) check box when
selected (default) allows link management by activating the port.

Frequency (MHz) indicates the frequency used for transmission.
World Wide Name (WWN)
The following WWN settings are only available when the Login - Enable
check box is selected.

Source allows to set the 64 byte WWN address of the local fibre
channel port: 00-00-00-00-00-00-00-00 to FF-FF-FF-FF-FF-FF-FF-FF
(default is 20-00-00-30-1[IEEE-MAC lsb (bits 27..0)).

Destination allows to set the 64 byte WWN address of the remote fibre
channel port: 00-00-00-00-00-00-00-00 (default) to
FF-FF-FF-FF-FF-FF-FF-FF . The destination WWN address is displayed
and grayed-out for Point-to-Point topology after a successful login.