EXFO FTB-800 Series for FTB-1 - Manual (Page 174)

Test Setup - Test Configurator, Timer, and System
164 FTB-700G/800 Series
Network
Network
From the test menu tap Setup, Test Configurator, the interface block, and
the Network tab.
Note: For Through Mode test application, the Network tab is only available for the
Primary Port but the configured parameters apply to both ports.
MAC

MAC Address indicates and allows to change, when the Factory
Default check box is cleared, the default and unique Media Access
Control (MAC) address given to the Ethernet port.

Factory Default check box, when selected (default), indicates that the
factory source MAC address is used.

Frame Format (layer 2) allows to select Ethernet II (default) or 802.3
SNAP
1
as the frame format.
1. Only available for 10M to 10G.