EXFO FTB-800 Series for FTB-1 - Manual (Page 166)

Test Setup - Test Configurator, Timer, and System
156 FTB-700G/800 Series
MAC/IP/UDP
IP
For IPv4 the following configuration parameters are available.

Automatic IP (DHCP) check box, when selected (cleared by default),
allows to dynamically obtain an IP address from a DHCP (Dynamic
Host Configuration Protocol) server.

Source IP Address allows to enter the source IP address for the
stream. The default setting is 10.10.x.y, where x and y are respectively
the two least significant bytes of the port default MAC address. Not
available when the Automatic IP (DHCP) check box is selected.

Destination IP Address allows to enter the destination IP address for
the stream. The default setting is the source IP address.
For IPv6 the following configuration parameters are displayed: Source
Link-Local IPv6 Address, and Source Global IPv6 Address. Tap on the
IPv6 Config button to access all settings.
IP

Link-Local IPv6 Address (LLA) is used for local communication
between on-link neighbors and for Neighbor Discovery process.

Mode
Stateless Auto (default) allows automatic generation of the IPv6
address based on the MAC address.
Static allows to enter the IP Address.

Address, available with Static mode, allows to select the
Link-Local IPv6 Address. The accepted range is from
FE80:0000:0000:0000:0000:0000:0000:0000 to
FE80:0000:0000:0000:FFFF:FFFF:FFFF:FFFF. The default address
is FE80::[Interface ID], where [Interface ID] is generated from
the source MAC address. When the Address field is selected for
editing using virtual keyboard, the Previous IPs button appears
allowing to select a previously configured IP address.