Thresholds button – EXFO FTB-800 Series for FTB-1 User Manual
Page 189
Test Setup - Test Configurator, Timer, and System
NetBlazer
179
RFC 2544 - Subtests
Thresholds Button
Note: For Dual Test Set, thresholds are configurable for Local to Remote and
Remote to Local directions at the exception of Round-Trip Latency
Threshold for which the value is unique.
Throughput Threshold allows to set the threshold
1
value used to
declare a pass/fail verdict and it applies to all frame sizes when
applicable. The range is as follows:
Back-to-Back Threshold allows to set the threshold
1
value in
percentage of frames per burst to declare a pass/fail verdict. The range
is from 0.0 to 100.0% (default) and it applies to all frames sizes when
applicable.
Frame Loss Threshold (%) allows to set the threshold
2
value of frame
loss. The range is from 0.000 to 100.000 (default is 0.100) and it
applies to all frame sizes when applicable.
1. The verdict is PASS when the received/measured value is greater or equal to the threshold value.
Interface
Speed
Max. Rate
%
Mbit/s
Gbit/s
10 Mbit/s
0.000 to 100.000
a
a.
Defalut value.
0.000 - 10.000
Not Applicable
100 Mbit/s
0.000 to 100.000
0.000 - 100.000
Not Applicable
1000 Mbit/s
0.000 to 100.000
0.000 - 1000.000
0.000 - 1.000
10G LAN
0.000 to 100.000
0.000 - 10000.000
0.000 - 10.000
10G WAN
b
b.
The maximum value for 10G WAN may be lower depending on the frame size. The
maximum value will be adjusted for each frame size.
0.000 to 92.8571
0.000 - 9230.769
0.000 - 9.230
2. The verdict is PASS when the received/measured value is lower or equal to the threshold value.