EXFO FTB-800 Series for FTB-1 - Manual (Page 17)

NetBlazer 7
3 Getting Started
If the FTB-700G/800 Series has been purchased at the same time as the
FTB-1, the FTB-700G/800 Series module is pre-installed with the
appropriate software version. If the NetBlazer and OTDR is not already
installed, refer to the FTB-1 User Guide for more information on how to
install the module.
Turning On the Unit
Turn on the FTB-1. Refer to the FTB-1 platform user guide for more
information.
Starting the Module Application
The module can be configured and controlled by starting the NetBlazer or
an OTDR application.
To start the NetBlazer application:
1. For FTB-800 Series, from Mini ToolBox tap the application button.
2. For FTB-700G Series, from Mini ToolBox select the
FTB-7xx Ethernet & Multi-Service module then tap NetBlazer
application button. Only one application can run at once, either
NetBlazer or one OTDR application.
Note: To start an OTDR application, refer to the FTB-700 Series user guide for
more information.
3. For the Restore Default prompt, tap Yes to restore the factory default
settings or No to preserve the settings from the last shut down. If the
user does not tap any button within 10 seconds the NetBlazer
application uses the settings from the last shut down. Select the
Disable Reminder check box to disable the display of this pop-up
every time the NetBlazer application is launched and to use the
settings from the last shut down. Refer to Save/Load tab on page 478
for more information.