EXFO FTB-800 Series for FTB-1 - Manual (Page 84)

Selecting and Starting a Test
74 FTB-700G/800 Series
Wireless Test Application
Wireless Test Application
To select, configure, and start a Wireless test:
1. From the test menu, tap Setup.
2. From the Test Applications tab, under Wireless, tap the CPRI/OBSAI
BERT test icon.
3. From the Test Configurator tab configure the interface structure and
its parameters.
3a. Tap the Modify Structure button to set the basic structure of the
test such as the interface/rate, connector, etc. (refer to Modify
Structure Button on page 84).
3b. Tap the interface block to configure the interface parameters
(refer to page 133). Ensure that the power level is present in the
status bar before proceeding to the next step (refer to Status Bar
on page 26).
3c. Tap the test block to configure the specific test settings (refer to
page 114).
Modify Structure
Test Block
Interface Block
Physical
Interface Port