EXFO FTB-800 Series for FTB-1 - Manual (Page 340)

Test Results
330 FTB-700G/800 Series
Service Performance
Service Performance
From the Test menu, tap Results, and the Service Performance tab.
Service Name and Selection
Service Name indicates the name of the selected service.
Select the service to be displayed by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific service
number. An orange background indicates the selected service while a
green background indicates the services that are enabled.
SLA Parameters
The configured CIR, Max Jitter, Frame Loss and Max Latency/Max
Round-Trip Latency SLA parameters are displayed. Refer to Services -
Profile on page 191 for more information. For Dual Test Set, parameters
are displayed for both local to remote (L -> R), remote to local (R -> L)
directions.
Metrics
Current, Average, Minimum, Maximum, and Estimate (Jitter) measured
values for each metric are reported. Direction, available with Dual Test Set
indicates results from local to remote (L -> R), remote to local (R -> L),
and Round-Trip for Latency when in Round-Trip Latency Measurement
Mode (see Global Options on page 123). For Dual Test Set, results for
remote to local are obtained at the end of each step.

RX Rate indicates the measured utilization throughput.

Jitter (ms) indicates the measured delay variation.

Latency (ms) indicates the measured round-trip latency (delay).
Note: For the Current value, 0 is displayed when no RX rate has been measured
in the last second.