Transmit operation interface signals, Transmit datapath interface signals – Altera IP Compiler for PCI Express User Manual
Page 330
B–12
Chapter :
Descriptor/Data Interface
IP Compiler for PCI Express User Guide
August 2014
Altera Corporation
Transmit Operation Interface Signals
The transmit interface is established per initialized virtual channel and is based on
two independent buses, one for the descriptor phase (tx_desc[127:0]) and one for
the data phase (tx_data[63:0]). Every transaction includes a descriptor. A descriptor
is a standard transaction layer packet header as defined
ion of bits 126 and 127, which indicate the
transaction layer packet group as described in the following section. Only transaction
layer packets with a normal data payload include one or more data phases.
Transmit Datapath Interface Signals
The IP core assumes that transaction layer packets sent by the application layer are
well-formed; the IP core does not detect malformed transaction layer packets sent by
the application layer.
Transmit datapath signals can be divided into the following two groups:
■
Descriptor phase signals
■
Data phase signals
1
In the following tables, transmit interface signal names suffixed with <n> are for
virtual channel <n>. If the IP core implements additional virtual channels, there are
additional sets of signals, each suffixed with the corresponding virtual channel
number.
describes the standard TX descriptor phase signals.
Table B–6. Standard TX Descriptor Phase Signals (Part 1 of 2)
Signal I/O
Description
tx_req<n>
I
Transmit request. This signal must be asserted for each request. It is always asserted
with the tx_desc[127:0] and must remain asserted until tx_ack is asserted. This
signal does not need to be deasserted between back-to-back descriptor packets.
tx_desc
<n>[127:0]
I
Transmit descriptor bus. The transmit descriptor bus, bits [127:0] of a transaction, can
include a 3 or 4 DWORDS PCI Express transaction header. Bits have the same meaning
as a standard transaction layer packet header as defined by the
of the header occupies bits [127:120] of
the tx_desc bus, byte 1 of the header occupies bits [119:112], and so on, with byte 15
in bits [7:0]. Refer to
Appendix A, Transaction Layer Packet (TLP) Header Formats
for
the header formats.
The following bits have special significance:
■
tx_desc[2]
or tx_desc[34] indicate the alignment of data on tx_data.
■
tx_desc[2]
(64-bit address) when 0: The first DWORD is located on
tx_data[31:0]
.
■
tx_desc[34]
(32-bit address) when 0: The first DWORD is located on bits
tx_data[31:0]
.
■
tx_desc[2]
(64-bit address) when1: The first DWORD is located on bits
tx_data[63:32]
.
■
tx_desc[34]
(32-bit address) when 1: The first DWORD is located on bits
tx_data[63:32]
.