Teac SX-1 Reference Manual - Manual (Page 47)

Part IV–Mixer Controls
TASCAM SX-1 Reference Manual
47
Screen Control (VGA Channel Display)
Press the
CHANNEL
key in the
MAIN DISPLAY
MODE
section to recall the
Channel
screen. The mixer
channel displayed is determined by the Channel
Strip’s
SEL
key. The
Channel
display provides
onscreen access and control of all the selected chan-
nel’s features in a single display.
CONTROL The
CONTROL
module contains the
selected channel’s basic level, routing, bussing, and
monitoring controls. It is also possible to select a
channel for display directly from within this module.
Channel Select Click on the next to the channel
name (top left corner) to access a pop-up window of
all the mixer’s channels, groups, returns, and sends.
Select the channel you want to see and the entire
Channel screen will update to show that selection.
+/- keys Click on the
+/-
keys to step through the
mixer’s channels, groups, returns, and sends one at a
time.
TIP
The Channel Select field and +/- keys have the same effect
as actually pressing the SEL key on a Channel Strip.
RECORD
The
RECORD
enable key is identical to the
REC
enable key on a Channel Strip.
MUTE The
MUTE
key is identical to the
MUTE
key on
a Channel Strip.
SOLO The
SOLO
key solos the selected channel. It
works the same way as a Channel Strip’s
MUTE
key
does in solo mode.
EQ —> DYN Press this key to toggle the order of the
selected channel’s EQ and dynamics setup. The
choices are EQ pre- or post- the dynamics
processing.
1/2, 3/4, 5/6, 7/8 These keys assign the selected
channel to the 8 busses.