Teac SX-1 Reference Manual - Manual (Page 65)

Part IV–Mixer Controls
TASCAM SX-1 Reference Manual
65
CH 1-16 and CH 17-32 The bussing pages are
set up in two groups of 16 channels each. These keys
select the channels you want to view.
MACRO These “macro” commands
allow busses on all the channels to be
turned on or off at the press of a single
soft key.
1-8/ALL OFF Turns any of the eight ste-
reo busses that are on, off (does not
include the Cue buss).
ST/ALL OFF Unassigns all of the mixer channels
from going to the stereo Master L/R buss.
ST/ALL ON Assigns all of the mixer channels to the
Master L/R buss.
Buss Assign Press the
Buss Assign
soft
key to open the buss select menu for the
selected mixer channel. (Select the
mixer channel by pressing
SEL
on the
channel in question, or by using the Left/
Right arrow keys of the Keypad).
1-2 to 7-8 These keys assign the
selected mixer channel to their respec-
tive busses.
CUE This key assigns the selected mixer channel to
the Cue output.
ST This key assigns the selected mixer channel to the
Master L/R output.
RET 1-8 This screen shows the return assignments,
as well as the assignment of the busses to the stereo
buss.
Aux Sends & Returns
The mixer features six Aux Sends and eight Returns.
The Aux Send controls are available from the sur-
face, the VGA, and the LCD screens. Aux sends can
be routed internally, or externally to the four Aux
Send jacks on the top panel (and, for that matter, any other external jack using the SX-1’s flexible routing).
The Returns can accept input from nearly any source,
internal or external. Routing for the Returns is con-
figured in the
Mixer Routing
tab of the VGA
Routing
screen.
VGA Aux Send Controls
Aux send levels can be controlled
from the VGA
Channel
screen in the
AUX SEND
module and from the LCD
MIXER CHANNEL
page. Identical con-
trols (pictured left) are also found
on the channels in the
Mixer
screen.
All 6 Aux Sends are also part of the
Virtual Channel Strip for each
channel.