Paradyne T1 T1 Access Mux 926x - Manual (Page 110)

Setting Up
5-56 9161-A2-GH30-30 April 1998
Table 5-10. Communication Port Options (5 of 5)
RIP
Possible Settings: None, Proprietary
Default Setting: None
Specifies which routing information protocol (RIP) is used to enable routing of
management between devices.
H RIP only appears if Port Use is set to Net Link.
NOTE: Changing this setting does not affect the current session; it changes all
subsequent sessions.
None – No routing is used. Use this setting when the device at the other end of the
management link is not a Paradyne device.
Proprietary – A proprietary variant of RIP version 1 is used to communicate routing
information between devices to enable routing of IP traffic.