Paradyne T1 T1 Access Mux 926x - Manual (Page 145)

Displaying System Information
7-3 9161-A2-GH30-30 April 1998
Chapter 7, Maintenance and Troubleshooting , contains a list of all status
messages and recommended action for you to take. Use the following menu
sequence to display system and test status information.
Main Menu
→
Status
→
System and Test Status
Displaying Voice APM Status
Use the Voice APM Status screen to display information concerning voice cards
that you have installed in your system.
"
Procedure
1. Follow this menu sequence to display the Voice APM Status screen.
Main Menu
→
Status
→
Voice Status
2. Enter the slot number of the desired voice APM in the SLOT field. The Voice
Port Status screen differs, depending on whether you are accessing an E&M,
FXO or FXS Voice APM.
View this field . . . To find the . . .
For the E&M Voice APM
Port Status Status of the port.
Assigned To Interface the port is assigned to.
Operating Mode Operating mode of the voice port that was configured
using the Operating Mode configuration option on the
Voice Ports screen. See the
Technical Reference for
configuration information.
Signaling Type Type of signaling used by the voice port that was
configured using the switches on the E&M APM. See
the
9109 E&M Analog Voice Application Module (APM)
Installation Instructions for more information.
Call Progress Current condition of the port.
TX ABCD bits Current value of the ABCD bits that are being
transmitted to the T1 interface.
RX ABCD bits Current value of the ABCD bits that are being received
from the T1 interface.
E-Lead State Current status of the E-lead (On or Off).
M-Lead State Current status of the M-lead (On or Off).
Trunk Cond CGA Displays the status of trunk conditioning (On for CGA,
Off for no CGA).