Paradyne T1 T1 Access Mux 926x - Manual (Page 158)

Displaying System Information
7-16 9161-A2-GH30-30 April 1998
Clearing Performance Statistics
Use the following menu sequence to clear performance statistics.
Main Menu
→
Status
→
Clear Statistics
You can also use the ClrStats function at the bottom of the Performance Statistics
screen.
To clear all . . . Select . . .
User performance registers, including
network and ports statistics All
User performance registers for the
selected Network Interface Network 1 or Network 2 (only the Model
926x provides Network 2)
Performance registers for all Sync Data
ports All Sync Data Ports
NOTE:
You can only clear User statistics. Telco statistics cannot be cleared.
Status Information
Select system and test status information from the Status menu:
Main Menu
→
Status
→
System and Test Status
System Status Messages
These messages, listed in alphabetical order, appear in the messages area at the
bottom of the screens (see Table 7-1).
Table 7-1. System Status Messages (1 of 2)
Message What It Indicates What To Do
Already Active The selected test is currently
running. 1. Allow test to continue.
2. Stop the test.
Command Complete A system command (save,
clear, abort) completed
normally. No action needed.
Connection Refused User interface is in use. This
will only appear during
initiation of a Telnet session. Wait and try again.