Paradyne T1 T1 Access Mux 926x - Manual (Page 174)

Operation and Maintenance
8-6 9161-A2-GH30-30 April 1998
6. Follow this menu selection sequence, pressing Return after each selection:
Configuration Edit/Display
→
Alarm
The Alarm Options screen appears.
7. Select and set the following configuration options, as appropriate.
To . . . Set the configuration option . . .
Automatically initiate a call (dial out) Alarm & Trap Dial-Out to Enable.
Retry the call if the call cannot be
completed H Call Retry to Enable
H Dial-Out Delay Time to the desired
number of minutes
H Alternate Dial-Out Directory to the
desired directory
Specify whether to disconnect
immediately after dialing out traps, or to
allow a manual disconnect to occur. (A
connection remains until manually
disconnected.) Trap Disconnect to Enable.
8. Press Ctrl-a to switch to the screen function key area.
9. To save changes, select Save and press Return.
10. Select the configuration area where you want to save the changes to and
press Return.
When Save is complete, Command Complete appears at the bottom of the
screen.
Maintaining COM Port Directories
Two Control menu selections are dedicated to dialing a remote device for
management:
Select . . . To . . .
COM Port Call Setup Select a phone directory and view its phone number, or
to initiate and terminate external modem connections
over the FrameSaver unit’s COM port. Used for
management.
COM Port Call Directories Change the phone number contained in a selected
directory when using an external modem.
Displaying Directory Numbers
Use the COM Port Call Setup screen to display the telephone number of the
remote device.
Main Menu
→
Control
→
COM Port Call Setup