Paradyne T1 T1 Access Mux 926x - Manual (Page 202)

Troubleshooting
9-20 9161-A2-GH30-30 April 1998
6. Press Ctrl-a to switch to the screen function key area.
7. To save changes, select Save and press Return. The Save Configuration To
screen appears.
8. Select the configuration area where you want to save the changes to and
press Return. When Save is complete, Command Complete appears at the
bottom of the screen.
Manual Dialing Out When an Alarm Occurs
Configure the external device connected the the access unit’s COM port. Then,
use the COM Port Call Setup screen to:
H
Select the desired telephone number.
H
Dial a call.
H
Disconnect a call.
"
Procedure
1. Follow this menu selection sequence:
Main Menu
→
Control
→
COM Port Call Setup
2. Enter the desired directory number, or press the spacebar to cycle through
the numbers that have been set up in the directory. The telephone number
appears in the Directory Phone Number field.
See Displaying Directory Numbers and Changing Directory Numbers in
Chapter 8, Operation and Maintenance, for information about the call
directory.
3. Select Dial and press the Enter key to initiate dialing.
4. To end the call, select Disconnect and press the Enter key.