Paradyne T1 T1 Access Mux 926x - Manual (Page 32)

Management and Control
2-4 9161-A2-GH30-30 April 1998
Configuring End-to-End Management Control
When managing the T1 access unit remotely, you can establish a management
link across the network in one of three ways. You can:
H Use the Facility Data Link (FDL) for a point-to-point ESF T1 link.
H
Use an Embedded Data Link (EDL) associated with a Sync Data port.
H Use a Direct Data Link (DDL).
Management Control Using the ESF FDL
You can configure the T1 access unit to use FDL as a management link if
available for a point-to-point, ESF T1 link, where FDL is end-to-end.
496-15183
LAN
T1 Access
Unit A
Physical Connection
FDL
T1
Network
T1 Access
Unit B
NMS
As shown in the example, in-band management is accomplished through the FDL
between the two T1 access units. Management data for T1 Access Unit B goes to
T1 Access Unit A, which then routes it into the FDL between the units. This
example assumes that the NMS (or Host) that is attempting to access T1 Access
Unit B is attached (using SLIP or PPP) via the COM port on T1 Access Unit A.
Set the Management Link configuration option to FDL.
Menu selection sequence:
Main Menu
→
Configuration
→
Network Interface