Index
IN-9
9161-A2-GH30-30
April 1998
status
cross connect, 7-7
menu/branch, 4-2
SNMP-to-user interface cross-reference, D-1
system, 7-2
test, 7-2
voice APM, 7-3
Status Messages, 7-17
Stop Bits, 5-54
stopping a test, 9-43
subnet
assigning IP addresses and masks, B-7
routing using different, B-5
routing using same, B-4
Subnet Mask, 5-10, 5-21
switching, between screen areas, 4-8
Sync Data Performance Statistics, 7-12
sync data port, configure, 5-16
sync data ports, assigning, 5-44
Sync Data Ports , worksheet, A-6
Synchronous Data APM, 1-5
Synchronous Data Port options, 5-17
system
Error Messages, 9-18
health messages, 7-17
identity information, 7-1
messages, 4-4
Name, Contact, and Location, 7-1
Status Messages, 7-16
System Alarm Relay, 5-66
System Options, worksheet, A-11
T
T1
interfaces, configuring, 5-7
Line Interface Cable, E-5
mass termination cable, E-26
Network Interface Connector, E-5
RJ48S network cable, E-4
T1 Access Unit, features, 1-6
T1 access unit, resetting, 8-13
Tab key, 4-5
TCP, 8-9
technical specifications, F-1
Telnet
limiting access, 6-3
setting up to support, 5-61
Telnet Login Required, 5-62, 6-3
Telnet Session, 5-62, 6-3
Telnet/FTP Session options, options, 5-62
Terminating Impedance (ohms)
FXO, 5-27
FXS, 5-30
Test
menu/branch, 4-2
SNMP-to-user interface cross-reference, D-7
Test Duration, 5-49
test jacks, 1-9, 9-8
Test Status Messages, 7-17, 7-24
Test Timeout, 5-48
Test Tones, 9-34
tests, 1-9
aborting, 9-44
analog loopback, 9-33
available, 9-21
data channel loopback, 9-30
data loopback, 9-42
data port, 9-28
device, 9-42
digital loopback, 9-33
DS-0 loopback, 9-40
DTE loopback, 9-28
DTE Payload Loopback, 9-29
interface, 9-22
latching loopback, 9-39
line loopback, 9-23, 9-41
line loopbacks, 9-34
nonlatching loopback, 9-39
OCU loopback, 9-40
OCU-DP, 9-37, 9-38, 9-42
payload loopback, 9-24
Remote FT1 Data Channel Loopback, 9-31
remote loopback, 9-26
repeater loopback, 9-25
send and monitor pattern, 9-27, 9-32
starting, 9-43
Status and Results, 9-44
stopping, 9-43
Timeout, 9-43
Tones, 9-34
V.54 remote loopback, 9-30
voice port, 9-32
time, setting, 5-4
Timeout, Test, 9-43
Transmission Control Protocol, 8-9
Transmit Clock, 5-18