Paradyne T1 T1 Access Mux 926x - Manual (Page 159)

Displaying System Information
7-17 9161-A2-GH30-30 April 1998
Table 7-1. System Status Messages (2 of 2)
Message What To Do What It Indicates
Please Wait Command takes longer than
5 seconds. 1. Wait until message clears.
2. If the message does not
clear within 2 minutes, reset
the device.
User Interface Already
in Use Access to the user interface
via Telnet is in use; access to
the interface is denied.
IP address and login of the
user currently accessing the
interface are also provided.
1. Wait and try again.
2. Contact IP address user
and request that they log
off.
User Interface Idle Previously active session is
now closed/ended, and
access via the COM port is
now available. Log onto the access unit.
Session has ended due to
timeout. Normal condition; no action
needed.
System Health and Test Status Messages
The System and Test Status screen ( Path: main
→
status
→
system
→
test status)
displays the following types of messages:
H Health and Status – Displays Health and status information in priority order
(highest to lowest).
H
Self-Test Results – Displays the results of the power-up self-test
diagnostics.
H Test Status – Indicates which tests are currently active.
Health and Status Messages
These messages appear in the first column of the System and Test Status screen
in priority (highest to lowest) order, as shown in Table 7-2.
Clear device failure messages from the System Health and Status screen using
the following menu selection sequence:
Main Menu
→
Control
→
Clear Device Fail