Paradyne T1 T1 Access Mux 926x - Manual (Page 273)

SNMP Cross-Reference
D-15 9161-A2-GH30-30 April 1998
Table D-1. SNMP MIB to User Interface Command Cross-Reference (15 of 16)
User Interface Command SNMP MIB Object
CONFIG
main/config/ocu:
Port Status
Port Rate
Loopback Detection
Set/Read:
ifAdminStatus to up or down
devOcuRate
devOcuLoopbackDetection
main/config/cross_connect:
DSX-1-to-Network Assignments
Network to Network Assignments
Voice Port Assignments
Sync Data Port Assignments
OCU-DP Port Assignments
Clear DSX-1 Time Slots
Clear Network Interface Time Slots
Clear Slot
nn
Fully supported by the device cross-connect MIB objects using:
devDs1FracTable
devDs1FracTable
devDs1FracTable
devSyncDataPortAssignTable
devDs1FracTable
Use devDs1FracTable to clear all time slots
Use devDs1FracTable to clear all time slots
Use devDs1FracTable to clear all time slots
main/config/system:
Test Timeout
Test Duration
Primary Clock Source
Secondary Clock Source
Set/Read:
devConfigTestTimeout
devConfigTestDuration
devConfigClockSrcTable (read only)
devConfigClockSrcTable (read only)
main/config/user/com:
COM Port
Port Usage
Port Type
Data Rate
Character Length
Parity
Stop Bits
Ignore Control Leads
Clock Source
Set/Read:
devPortUsage to netlink, alarm, or terminal
See the Asynchronous/Synchronous Port Table for the entry
rs232PortInSpeed or rs232PortOutSpeed for the port
rs232AsyncPortBits for the port
rs232AsyncPortParity for the port
rs232AsyncPortStopBits for the port
rs232PortInFlowType for the port
rs232SyncPortClockSource to
internal or external
main/config/management/security:
IP Address
Access Type
Set/Read:
devSecurityMgrIpAddress
devSecurityMgrAccess to
read or readWrite
main/config/management/trap:
IP Address
Destination
General Traps
Enterprise-Specific Traps
Link Traps
Link Traps Interfaces
Set/Read:
devTrapMgrIpAddress
devTrapMgrDestination
devConfigTrapEnable
devConfigTrapEnable
devConfigTrapEnable
ifLinkUpDownTrapEnable for the interface