Paradyne T1 T1 Access Mux 926x - Manual (Page 269)

SNMP Cross-Reference
D-11 9161-A2-GH30-30 April 1998
Table D-1. SNMP MIB to User Interface Command Cross-Reference (11 of 16)
User Interface Command SNMP MIB Object
main/test/port (voice):
Start Digital Loopback
Stop Digital Loopback
Start Analog Loopback
Stop Analog Loopback
Start Line Loopback
Stop Line Loopback
Start Send DRS to T1
Stop Send DRS to T1
Start Send DRS to User
Stop Send DRS to User
Start Send Quiet to T1
Stop Send Quiet to T1
Start Send Quiet to User
Stop Send Quiet to User
Set devVoiceTestType to: With devVoiceTestAction set to:
digitalLoopback start
digitalLoopback stop
analogLoopback start
analogLoopback stop
lineLoopback start
lineLoopback stop
networkDRSTone start
networkDRSTone stop
userDRSTone start
userDRSTone stop
networkQuietTone start
networkQuietTone stop
userQuietTone start
userQuietTone stop
main/test/port (voice):
Set Tx ABCD Bits
Set Rx ABCD Bits
Set Tip & Ring Leads
Set E-Lead State
Tx ABCD Bits
Rx ABCD Bits
Tip & Ring Leads
E-Lead State
M-Lead State
Set devVoiceTestType to: With devVoiceTestAction set to:
testTXBits start and devVoiceTestArgument
specifying the ABCD bit values
testRXBits start and devVoiceTestArgument
specifying the ABCD bit values
testTRLeads start and devVoiceTestArgument
specifying Tip and Ring values
testELeads start and devVoiceTestArgument
set to
idle or active
From devVoiceTestType Read:
testTXBits
testRXBits
testTRLeads
testELeads
testTRLeads