Paradyne T1 T1 Access Mux 926x User Manual

Page 81

Advertising
background image

Setting Up

5-27

9161-A2-GH30-30

April 1998

Table 5-5.

FXO Voice – Slot ss Port p Options (2 of 3)

Signaling Type

Possible Settings: Loop-Start, Loop-Start/Fwd Disc, Ground-Start
Default Setting: Loop-Start

Determines the type of signaling for the FXO voice port.

H

Signaling Type only appears if:

– Port Status is set to Enable.

– Operating Mode is not set to DPT.

Loop-Start – Enables the signaling used for basic telephone service stations, simple
PBX trunks, or key systems.

Loop-Start/Fwd Disc – Enables the signaling used for automated answering
equipment.

Ground-Start – Enables the signaling used for two-way PBX trunks. Helps to prevent
“glaring”, i.e., call collision.

Terminating Impedance (ohms)

Possible Settings: 600, 900
Default Setting: 600

Determines the terminating impedance (in ohms) for the port.

H

Terminating Impedance only appears if Port Status is set to Enable.

600 – The terminating impedance is 600 ohms.

900 – The terminating impedance is 900 ohms.

Wink Delay (10 ms)

Possible Settings: 1 – 99
Default Setting: 15

Determines the amount of delay before the wink signal is generated towards the
network, and when an off-hook signal from the CO is detected in increments of
10 milliseconds.

H

Wink Delay only appears if:

– Port Status is set to Enable.

– Operating Mode is set to FXODN/WINK or DPT.

10 to 990 – The valid range is from 10 to 990 ms, in 10 ms increments. The settings are
numbers between 1 and 99, representing such increments. The default is 15, for a wink
delay of 150 ms.

Wink Duration (10 ms)

Possible Settings: 1 – 99
Default Setting: 20

Determines the duration of the wink signal generated towards the network when an
off-hook signal for the CO is detected and after the wink delay has elapsed in
increments of 10 milliseconds.

H

Wink Duration only appears if:

– Port Status is set to Enable.

– Operating Mode is set to FXODN/WINK or DPT.

10 to 990 ms – The valid range is from 10 to 990 ms, in 10 ms increments. The settings
are numbers between 1 and 99, representing such increments. The default is 20, for a
wink duration of 200 ms.

Advertising