Paradyne T1 T1 Access Mux 926x - Manual (Page 180)

Operation and Maintenance
8-12 9161-A2-GH30-30 April 1998
Backing Up Your Configuration
You may choose to back up your configuration files in case recovery is needed.
The following configuration files correspond to the configuration areas in your T1
access unit.
Configuration File Configuration Area
current.cfg Current
cust1.cfg Customer 1
cust2.cfg Customer 2
factory.cfg 1 Factory
1 You cannot put to this file since it is read-only
NOTE:
If you maintain a backup copy of your configuration files, you should upload a
new backup copy of your configuration from the T1 access unit after you
upgrade to a new release of software.
"
Procedure
To copy configuration files from the T1 access unit:
1. Initiate an FTP session to the device that you are backing up.
2. Type bin to enter binary mode.
3. Type cd system to change to the system directory.
4. Type get < filename> to perform a get of the desired file(s).
5. Type quit to exit the FTP session.
"
Procedure
To restore configuration files to the T1 access unit:
1. Initiate an FTP session to the device that you are backing up.
2. Type bin to enter binary mode.
3. Type cd system to change to the system directory.
4. Type put < filename> to perform a get of the desired file(s).
5. Type quit to exit the FTP session.