Paradyne T1 T1 Access Mux 926x - Manual (Page 238)

Menus and Configuration Worksheets
A-12 9161-A2-GH30-30 April 1998
Device Name: ___________________________________________________________
User Interface
Configuration Option Settings Default in [Bold]
Communication Port See Table 5-10
Port Use [Terminal], Net Link, Alarm
Port Type [Asynchronous], Synchronous
RIP 1 [None], Proprietary
Port Type – Synchronous
Clock Source [Internal], External
Data Rate (Kbps) 2 9.6, 14.4, [19.2], 28.8, 38.4, 57.6, 115.2
Port Type – Asynchronous
Data Rate (Kbps) 9.6, 14.4, [19.2], 28.8, 38.4 57.6, 115.2
Character Length 3 7, [8]
Parity 3 [None], Even, Odd
Stop Bits 3 [1], 1.5 ,2
Ignore Control Leads 3 [Disable], DTR
Login Required 4 Enable, [Disable]
Port Access Level 4 [Level-1], Level-2, Level-3
Inactivity Timeout 4 Enable, [Disable]
Disconnect Time (Minutes) 4 ,5 1 – 60 [5]
External Device (COM Port) See Table 5-11
External Device Commands [Disable], AT, Other
Dial-In Access 6 Enable, [Disable]
Connect Prefix 7 ASCII text entry, Clear
Connect Indication String 7 ASCII text entry, Clear
Escape Sequence 7 ASCII text entry, Clear
Escape Sequence Delay (Sec) 7 [None], 0.2, 0.4, 0.6, 0.8, 1.0
Disconnect String 7 ASCII text entry, Clear
1 Only shown when Port Use is set to Net Link.
2 Only shown when Clock Source is set to Internal.
3 Only shown when Port Type is set to Asynchronous.
4 Only shown when Port Use is set to Terminal.
5 Only shown when Inactivity Timeout is set to Enable.
6 Only shown when External Device Commands is set to Other or AT.
7 Only shown when External Device Commands is set to Other.