Lenze Engineer v2.21 - Manual (Page 100)

Device functions with active online connection
Controlling an inverter: Enable/inhibit, start stop application
100
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2 Controlling an inverter: Enable/inhibit, start stop application
The control functions can be executed when a device has been inserted into the project (example:
Inverter Drives 8400 and Servo Drives 9400) and an online connection to the device has been
established.
• The control functions can be executed via the Toolbar or the Online menu:
7.2.1 Enable controller

How to deactivate controller inhibit:
1. Select the controller for which the controller inhibit is to be deactivated in the Project view.
2. If no online connection to the device has been established yet:
Click the icon or select the menu command Online  Go online to establish an online
connection to the device.  Going online ( 77)
3. Click the icon or select the menu command Online  Enable controller.
4. Confirm the safety query on whether the controller is to be enabled with Yes.
• Then the controller inhibit in the controller is deactivated if there is no further
precondition for a controller inhibit (e. g. via digital terminal).
• By clicking or via the menu command Online  Inhibit controller you can set
controller inhibit in the controller again.
The controller enable is displayed in the status bar:  Status information ( 23)

Stop!
If a system module that contains several devices has been selected instead of a device in
the Project view, the respective control function is executed in all the devices of the
system module to which an online connection has been established.
Icon Menu command Be sure to observe: Shortcut
Enable controller ( 100) 
 Safety instructions ( 12)
<F8>
Inhibit controller ( 101) <F9>
Start application ( 101) 
 Safety instructions ( 12)
Stop application ( 101)

Danger!
During commissioning persons must keep a safe distance from the motor or the
machine parts driven by the motor. Otherwise there would be a risk of injury by moving
machine parts.