Lenze Engineer v2.21 - Manual (Page 296)

Appendix
User motors
296
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.4.2 Saving a user motor to the user motor catalogue
A user motor can be saved to a user motor catalogue to be reused in other »Engineer« projects.

How to save a user motor:
1. Select a user motor in the »Engineer« project that has been created.
2. Right-click the user motor: Select the Save motor to catalogue command.
• The Save user motor in catalogue dialog box shows the identification features/
properties and nameplate data of the user motor.
• The parameters can be changed any time later on.
3. Click Next.
• The default values for the controller selected are displayed.
• If there already is a motor of the same name in the user motor catalogue, you will be
asked whether you would like to save the motor under another name or whether you
would like to replace the motor that has been saved under that name so far.
Alternatively, certain default value sets can be transferred to the user motor already
saved in the catalogue.
4. Click Complete.
• Note: A user motor already saved in the user motor catalogue can be extended by
additional data. Default values for 8400 controllers e.g. can be added to a motor which
only contains default values for 9400 controllers so far.