Lenze Engineer v2.21 - Manual (Page 256)

Error messages
Communication entity generator
256
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Error during creation of the EXTENSION_BOARD_SLOT Mappings/Task Context [CE94PRF0003]
Error during creation of the EXTENSION_BOARD_SLOT Mappings. Task {0} does not exist on runtime system [CE94PRF0004]
Invalid data width [CE94PRF0005]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
For the indicated PROFIBUS module, the mapping code
between the control configuration module and the port
variables cannot be entered in the task configuration.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Internal error. For the indicated PROFIBUS module, the
mapping code between the control configuration
module and the port variables cannot be entered in the
task configuration because the task indicated for the
port does not exist on the runtime system.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Internal error. The data type of an element variable is not
supported for the indicated port.