Lenze Engineer v2.21 - Manual (Page 208)

Inserting & configuring a network
Inserting a network
208
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4. Click the Next button.
Step 2 - Nodes
5. Highlight the corresponding nodes.
• The nodes that are not connected are displayed.
• If you click the Select all and Reset buttons, all the control fields are highlighted or the
highlighting is removed.
6. Click the Next button.