Lenze Engineer v2.21 - Manual (Page 188)

Defining the system functionality
Creating an interconnection via the electrical shaft
188
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7. In the field on the left entitled Available axes, select the axis that is to be assigned to the
interconnected (electrical shaft) system and click the button to assign the selected axis
to the interconnection.
The Add device to interconnection dialog box displays the assignment of the measuring
system for the master value:
• By clicking the Create new measuring system button, you can also create a new
measuring system if necessary in order to subsequently assign it to the master value.
8. Select a measuring system for the master value in the list field entitled Measuring system
master value.
• This measuring system is used as default setting for the x axis in the worksheet of the
»Cam editor«.
9. Click the Next button to accept the settings and to close the dialog box entitled Add device
to interconnection.
10. Repeat steps 7 to 9 for the other axes that are to belong to the interconnection via the
electrical shaft.
11. Click the Complete button to accept the settings and close the wizard.
After inserting the electrical shaft...
... it is shown in the Project view with the assigned axes:
Interconnection, Measuring systems, Cam Manager & Connections
If you select an electrical shaft in the Project view, the Workspace contains the Interconnection,
Measuring systems, Cam Manager and Connections tabs.