Lenze Engineer v2.21 - Manual (Page 224)

Inserting & configuring a network
CAN network
224
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• In the SYNC application parameters for: group field, further parameters of the SYNC receivers
selected are shown. These parameters are device-specific and, except for the SYNC source, are
not set automatically.
• Exception
• If the parameter that indicates SYNC source C1120/0 has been set for a 9400 field device and
if the Appl. (*1) control field has been highlighted for a node in the SYNC receiver table, C1120
is set to CAN on board or CAN Module.