Lenze Engineer v2.21 - Manual (Page 68)

Mapping the system structure in the »Engineer« project
Inserting a device detected online
68
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• The »Engineer« reads out the device configuration (firmware version and module assembly).
The »Engineer« determines the original configuration the application was created for if this
process is supported by the device.
• If there is a difference between the original and the actual configuration, you can select which
configuration is to be inserted into the project tree.

How to insert the field device online into the project:
1. Select the desired position for insertion in the Project tree.
2. Select the InsertDevice detected online menu command.
3. Select the suitable bus connection from the Bus connection selection field.
4. Press Start Search.
• Identified devices can be inserted into the project. Information provided under must
be observed if the device description is not suitable.

Note!
• For online recognition, the desired field device must ...
• ... be switched on.
• ... support online recognition.
• An unidentified device/module cannot be inserted into the project.

Note!
• Only the original version can be inserted if ...
• ... the version of the safe parameter set for the SM301 safety module varies:
Insertion into the project without further inquiry.
• ... a device description for the current firmware version is missing. The »Engineer«
is only provided with the version used for the original creation of the application:
The device recognised online is listed with the
icon under identified devices.