Lenze Engineer v2.21 - Manual (Page 239)

Lenze · Engineer · 2.13 EN - 10/2014
239
Error messages
Application Connection Generator
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Assignment of port to ProcessDataObject is missing [AC0004]
Definition of the network by means of port has failed [AC0005]
Connection beyond network limits cannot be closed [AC0006]
Connection cannot be closed [AC0007]
Data width of the target port differs from the source port [AC0008]
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Internal error
There is no connection between a port and a PDO.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Internal error
For an interconnected port, an attempt is made to find a
network by means of which the connection can be
established.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
An attempt is made to interconnect ports of various
devices that are not in a network.
For this purpose a gateway function is required, which is
not supported at present.
Add the nodes to be interconnected to a network.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Node is not connected to the network.
An attempt is made to interconnect ports of various
devices that are not in a network. A gateway function is
necessary for this but is not supported at the moment.
Add the nodes to be interconnected to a network.
Response (Lenze setting printed in bold)
 Error  Warning  Information
Cause Remedy
Ports of a different data width are tried to be connected. Adapt the sum of the element variable data widths of
the source and target ports in the port editor.
Only the unequivocal source port is indicated. The target
ports must be taken from the Port editor (application
interconnection editor).  Port editor (ports) ( 155)