Lenze Engineer v2.21 - Manual (Page 213)

Lenze · Engineer · 2.13 EN - 10/2014
213
Inserting & configuring a network
ETHERNET Powerlink network
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to insert a node into the network:
1. In the Network toolbar, click the icon.
• The Node selection dialog box is shown.
2. Select the node interface in the tree structure, the higher-level device of which is to be
inserted in the network as node.
• Devices containing only one node interface can be selected without opening them
further to the node interface in the tree structure.
3. Press OK.
4. The dialog box then closes and the selection is accepted.
• The node inserted is then displayed in the Network view as follows:
• In the Project view additionally all nodes of the network are listed as a "linkage" below the
network element:
• Repeat the Add node command if you want to insert further nodes into the network.