Lenze Engineer v2.21 - Manual (Page 222)

Inserting & configuring a network
CAN network
222
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Address range
Every node within the CAN network must be assigned a node address (node ID) as a clear means of
identification.
• For the nodes, node addresses in the range of 1 ... 63 can be allocated.
• Via the input fields Minimum node address and Maximum node address you can narrow this
range further.
• Via the input field Maximum number of nodes you can narrow the maximum number of the
possible nodes.
Restoring standard settings
By pressing Standard you restore the standard settings for the identifier range or the address range.