Lenze Engineer v2.21 - Manual (Page 136)

Defining the system functionality
Parameter setting in the »Engineer«
136
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Tip!
Via the Go to command in the Context menu you can go quickly to a parameter in the list
by entering the parameter number or name:
8.6.3 Altering a parameter offline
If you are "offline" and therefore are not connected with the device, the parameter settings for the
respective device saved within the project are displayed in the direct mode in the "Value" column:
• In the offline mode you can carry out all required parameter settings for a device, whereby the
corresponding device at this time does not have to be physically available or connected to the
PC.
• As a result, you can take your time in "preconfiguring" the project, for example, and you can
transfer the complete parameter set to the device at a later time.
• All settings in the parameter list are saved together with the project and thus are provided again
in the next »Engineer« session.
Icon Function
 Accepting parameter settings in the device ( 139) *
 Accepting the parameter settings of the device ( 138) *
 Resetting parameters to the default setting ( 138)
* Function only possible when an online connection has been established.
Offline parameter
Offline display parameter