Lenze Engineer v2.21 - Manual (Page 90)

Establishing an online connection
Going online
90
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Observe the naming of the controllers (the names of the components in question must be
identical in the »Engineer« and in »STEP 7«):
• 9400 for 9400 HighLine
• 8400 for 8400 StateLine
2. In the HW Config of »STEP 7« ...
...you create a PROFIBUS network.
... you create the desired Lenze PROFIBUS nodes and their respective node addresses.
• Example: a 94xx (address: 3) and an 84xx (address: 4) PROFIBUS:
Note: The selection of the process data configuration does not affect the TCI
communication!