Lenze Engineer v2.21 - Manual (Page 134)

Defining the system functionality
Parameter setting in the »Engineer«
134
Lenze · Engineer · 2.13 EN - 10/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.6 Parameter setting in the »Engineer«
Via the All parameters tab of a device or an application you can have the corresponding parameter
settings displayed and also edited, e.g. in order to define further functional settings for the device.

Tip: Specific search for parameters
Use the text field above the parameter list in order to search for parameter names,
parameter numbers or indices. The search is limited to the currently displayed parameter
list.
• The parameters are classified in different categories which you select via the buttons in area .
• Click on the desired categories button in area  to show the available subcategories.
• Click on the desired subcategory
to display the parameters in the area .
• Area  shows all parameters of the selected category / subcategory.
• By clicking the corresponding column header, you can alter the sequence of the parameter
list and change over between ascending and descending order.
• The Parameter list category shows all available parameters of the corresponding device.
• Using the DisplayInfo area command, the information area can be shown/hidden by right-
clicking into a parameter value. The information area shows further information on the
selected parameter below the parameter list.
8.6.1 Terminology used
Offline/online
With regard to the representation of the parameter setting, the modes "Offline" and "Online" are
differentiated.
• If no online connection to the device is available, the parameter list is in the "Offline mode". In
this mode the parameter list displays so-called "Offline parameters" presenting the parameter
settings of the device saved within the project.  Altering a parameter offline ( 136)