Lenze Engineer v2.21 - Manual (Page 219)

Lenze · Engineer · 2.13 EN - 10/2014
219
Inserting & configuring a network
CAN network
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• The inserted node will then be represented in the Network view:
9.4.1.2 Node settings
Configuration options in the network view
You can change the address of a node, its name and the designation of the device directly in the
Network view.

How to change a setting in the network view:
1. Click into the corresponding text field to change the respective setting:
2. Press <Input key> to accept the change.
Further configuration options
Further settings with regard to a node can be carried out via the Properties, Settings and Monitoring
tabs.

How to define the further settings of a node:
1. Select the node to be configured in the Network view.
• In the network view a selected node is highlighted by a green frame.
2. In the Network toolbar, click the icon.
• In addition, the Project tree shows all
nodes of the network as a link below
the network element.
• Repeat the Add node command if
you want to insert further nodes into
the network.

Further information about the CAN bus connection is provided in the documentation for
the respective controller.