Lenze Engineer v2.21 - Manual (Page 97)

Lenze · Engineer · 2.13 EN - 10/2014
97
Establishing an online connection
PROFINET address configurator
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Tip!
Detailed information on the system bus configurator can be found in the online help for the
system bus configurator.
6.5 PROFINET address configurator
Use the menu command OnlinePROFINET address configurator to open the "Allocate IP
addresses" dialog window, via which you can display and change the IP settings of PROFINET nodes.
• Use this command to prepare the desired PROFINET nodes for an online connection.
• By clicking the Search devices button you can carry out the search for connected devices again
any time.
6.6 EtherNet / IP addresses configurator
Use the menu command OnlineETHERNET/IP address configurator to open the "Allocate IP
addresses" dialog window, via which you can display and change the IP settings of Ethernet nodes.
• Use this command to prepare the desired Ethernet nodes for an online connection.
• By clicking the Search devices button you can carry out the search for connected devices again
any time.

Note!
The device search only shows devices which are connected via the local Ethernet
segment. Devices connected via a router/switch are not displayed.

Note!
The device search only shows devices which are connected via the local Ethernet
segment. Devices connected via a router/switch are not displayed.