Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 101)

Configuring the site
Access Manager 2000 User Manual 4-15
Access Manager 2000 supports 1 to 16 comlines operating at the
following rates:
The following are supported if no handshake protocol is used:
■
Leased-line circuits using full-time modems. This configuration is
specified as
DIRECT under the Access Arrangement
option.
■
Circuits that are direct-connected using short-haul modems
operating at 9600 baud.
Note: Before defining a Comline in the Access Manager database, make
sure the printed circuit board with the serial port(s) is installed in
your personal computer. Refer to AppendixD, "Installing Serial
Ports" for instructions on installing a standard serial board or
DigiBoard DigiCHANNEL board in your Personal Computer.
Comlines operating
at: Support
these connections:
1200 baud • direct
• ComDesign Multiplexer
• modem
2400 baud • modem
9600 baud • direct
• multiplexer
• modem (NCC 2020 controller only
• X.25 PAD (NCC 2020 controller only